Unit 4 Lab

Admin commands and one-offs

Resources / Important Links
Unit 4 on Killercoda Lab - https://killercoda.com/het-tanis/course/Automation-Labs/Unit4_Admin_Commands

Required Materials

Lab Server Killercoda recommended - https://killercoda.com/het-tanis/course/Automation-Labs/Unit4_Admin_Commands
Rocky 9.6+ - ProLUG Lab
Or comparable Linux box
`root` or `sudo` command access

Pre-Lab (Lab Setup)

If you're not doing the lab on Killercoda, make sure to follow the setup guide
below.

ProLUG Lab Setup

If you're using the ProLUG lab environment, run the following commands.

cd /root
cp -r /labs/automation/unit3/* /root
chmod 755 /root/*.sh
chmod 755 /root/*.py

Lab

This lab is designed to have the engineer verify and execute their automation tools to interact with the
OS in a controlled fashion.

If you do the killercoda Lab 4, just answer these questions. If you are doing the lab in the ProLUG
environment, find the scripts in `/labs/automation/unit4`.

In the ProLUG lab, you must edit /root/hosts to point at your correct environment based on which “auto<x>” 
server you have connected to.

|Server|Hostgroup|TargetNodes|
|:----:|:-------:|:---------:|
|auto1|[webservers]|target1-1,target1-2|
|auto2|[webservers]|target2-1,target2-2|
|auto3|[webservers]|target3-1,target3-2|
|auto4|[webservers]|target4-1,target4-2|
|auto5|[webservers]|target5-1,target5-2|